BIXOLON SLP-TX400 User Manual download pdf (Page 17)

Rev. 1.04

- 17 -

SLP-TX400x/TX403x

3-4-5 Narrow Ribbon Installation

When using ribbons of widths of 110mm or

lower, install in a centered position on the

holder ribbon.

3-4-6 Ribbon Removal

1) Use a knife or other sharp-edged object to cut the ribbon.

(Take care not to injure hands)

2) Open the ribbon assembly and remove the ribbon and core by pushing from left to right.

3) Detach the ribbon holder from the ribbon and core.

3-4-7 Ribbon Sensor Activation

Ribbon detection sensor is disabled by default factory settings. Check the settings related

to ribbon detection sensor if printing does not stop when the printer is out of ribbon or

ribbon is broken.

* Ribbon detection sensor can be enabled by command control. And default setting can

be changed by Unified Label Utility.

※ CAUTION

1. When replacing a ribbon, keep affixed the core of the fully used ribbon to the ribbon

coiling portion on the other side and do not discard as its use is required.

2. As the ribbon holder is required for continuous use, make sure not to misplace it.

Cutting

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 36 37

No comments

BIXOLON SLP-TX400 User Manual Page 17