User’s Manual SRP-F310/312 Front Exit Thermal Printer Rev. 1.00 http://www.bixolon.com
Rev. 1.00 - 10 -SRP-F310/3121-2-3 USB Interface Pin No. Signal Name Assignment (Color) Function Shell Shield Drain Wire Frame Ground 1 VBUS
Rev. 1.00 - 11 -SRP-F310/3121-4 Setting the Dip Switches 1-4-1 Serial Interface SW Function ON OFF Default 1-1 Auto-Cutter Selection Disable
Rev. 1.00 - 12 -SRP-F310/3121-5 Installing or Replacing the Paper Roll ※ NOTE Be sure to use paper rolls that meet the specifications. Do not use pa
Rev. 1.00 - 13 -SRP-F310/3121-5-5 Be sure to note the correct direction that the paper comes off the roll. 1-5-6 Pull out a small amount of paper
Rev. 1.00 - 14 -SRP-F310/3121-6 Adjustments and Settings The SRP-F310 is set up at the factory to be appropriate for almost all users. It does, howe
Rev. 1.00 - 15 -SRP-F310/3121-8 Connecting the computer You need an appropriate interface cable. 1-8-1 Plug the cable connector securely into the p
Rev. 1.00 - 16 -SRP-F310/3122. Self Test The self-test checks whether the printer has any problems. If the printer does not function properly, conta
Rev. 1.00 - 17 -SRP-F310/3123. Hexadecimal Dumping This feature allows experienced users to see exactly what data is coming to the printer. This can
Rev. 1.00 - 18 -SRP-F310/3124. Specification Printing method Thermal line printing Dot density SRP-F310: 180dpi(7dots/mm) SRP-F312: 203dpi(8dots/mm
Rev. 1.00 - 19 -SRP-F310/312 5. Appendix 5-1 Cleaning Printer Paper dust inside the printer may lower the print quality. In this case clean the pri
Rev. 1.00 - 2 - SRP-F310/312 Safety Precautions In using the present appliance, please keep the following safety regulations in order to prevent an
Rev. 1.00 - 3 - SRP-F310/312 CAUTION Violating following instructions can cause slight wound or damage the appliance. Do not use the print
Rev. 1.00 - 4 - SRP-F310/312 Warning - U.S.A This equipment has been tested and found to comply with the limits for a Class A digital device pursua
Rev. 1.00 - 5 - SRP-F310/312 Introduction The SRP-F310/312 Roll Printer are designed for use with electronic instruments such as system ECR, POS, b
Rev. 1.00 - 6 - SRP-F310/312 Table of Contents 1. Setting Up the Printer ...
Rev. 1.00 - 7 - SRP-F310/3121. Setting Up the Printer 1-1 Unpacking Your printer box should include these items. If any items are damaged or missin
Rev. 1.00 - 8 - SRP-F310/3121-2 Connecting the Cables You can connect up the three cables to the printer. They all connect to the connector panel on
Rev. 1.00 - 9 - SRP-F310/3121-2-2 Parallel Interface (IEEE1284) Pin No. Source Compatibility Mode Nibble Mode Byte Mode 1 Host nStrobe HostCl
Comments to this Manuals